Desktop Model Endurance Test Machine
Z-shape Bending Test

This equipment can realize the complex bending test which fold the test sample such a films and FPCs into three.

Attachment - Test JIG -

Z-shape Bending Test Jig

The bending radius plates will be turned as to roll up the test sample after clamping the test sample by the 2 bending radius plates. Test sample and bending radius plates are pressed, leaving the bending radius plates in 180 degrees turns.

Z-shape Bending Test
Z-shape Bending Test


Z-shape Bending Test

Completed Assembly

A safety cover is available for the flexible area as an option.

Z-shape Bending Test

Z-shape Bending Test

Z-shape Bending Test

±180° bending by tiny radius

This equipment can be tested minimum radius 0.1mm and maximum angle ±180° by changing spacer and thickness of bending radius plates. One side bending test can be also available.

Apply the bending force to test sample by pressure

The test machine has press mode and press-less mode. It will be press when test sample turns in ±180°. The pressure can be changed by the weight, also it can set the press-less mode. Press hours can be adjust by the timer.

Z shape folding tester is a special specification which used the driving unit for middle size. If you have any questions, please ask us.

Test Pieces
Planar Test Piece
  • Flexible Displays
  • Organic Electroluminescence Devices
  • Barrier Film
  • Flexible Printed Circuits
  • Flat Cables